Erasing Universal Remote System Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote system device:
1. Press and hold down the two outside buttons until the indicator light begins to flash.
This should take about 10 seconds.
2. Release both buttons.
See also:
Convenience Net
Use the convenience net, located in the rear, to store
small loads as far forward as possible. The net
should not be used to store heavy loads. ...
SBZA Detection Zones
The SBZA sensor covers a zone of
approximately one lane over from
both sides of the vehicle,
or 3.5m(11 ft). This zone starts at
each side mirror and goes back
approximately 5.0 m(16 ft). Th ...
Using the Delete All Name Tags Command
The delete all name tags command deletes all stored
phone book name tags and route name tags for OnStar
(if present).
To use the delete all name tags command:
1. Press and hold for two seconds. ...