Windshield Wiper Blade Replacement

Windshield wiper blades should be inspected for wear or cracking. See Scheduled Maintenance.

It is a good idea to clean or replace the wiper blade assembly on a regular basis or when worn. For proper windshield wiper blade length and type, see Maintenance Replacement Parts.

To replace the wiper blade assembly:

1. Turn the ignition to ACC/ACCESSORY with the engine off.

2. Pull the windshield wiper assembly away from the windshield.

3. Squeeze the tabs on each side of the wiper blade

3. Squeeze the tabs on each side of the wiper blade assembly and slide the assembly off the end of the wiper arm.

4. Replace the blade assembly with a new one.

4. Replace the blade assembly with a new one.

Allowing the wiper blade arm to touch the windshield when no wiper blade is installed could damage the windshield. Any damage that occurs would not be covered by your warranty. Do not allow the wiper blade arm to touch the windshield.

5. Repeat the steps for the other wiper.

    See also:

    Engine Power Messages
    ENGINE POWER IS REDUCED This message displays when the vehicle's engine power is reduced. Reduced engine power can affect the vehicle's ability to accelerate. If this message is on, but there is no ...

    Lumbar Adjustment
    To adjust the lumbar support: ► Press and hold the front or rear of the control to increase or decrease lumbar support. ► Press and hold the top or bottom of the control to raise or lo ...

    Windows
    WARNING: Leaving children, helpless adults, or pets in a vehicle with the windows closed is dangerous. They can be overcome by the extreme heat and suffer permanent injuries or even death from h ...