Using the Dial Command

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Dial”. The system responds with “Dial using <phone name>”. “Number please” followed by a tone.

3. Say the entire number without pausing.

• If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

• If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Dialing” and dials the number.

If the number is not correct, say “No”. The system will ask for the number to be re-entered.

    See also:

    Driving on Snow or Ice
    Drive carefully when there is snow or ice between the tires and the road, creating less traction or grip. Wet ice can occur at about 0°C (32°F) when freezing rain begins to fall, resulting ...

    Engine Oil Additives/Engine Oil Flushes
    Do not add anything to the oil. The recommended oils with the dexos specification and displaying the dexos certification mark are all that is needed for good performance and engine protectio ...

    Compass Messages
    CAL This message is displayed when the compass needs to be calibrated. See Compass . – – – Three dashes will be displayed if the compass needs service. See your dealer for service. ...