Using the Digit Store Command

The digit store command allows a phone number to be stored by entering the digits individually.

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Digit Store”. The system responds with “Please say the first digit to store” followed by a tone.

3. Say the first digit to be stored. The system will repeat back the digit it heard followed by a tone.

Continue entering digits until the number to be stored is complete.

• If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.

• To hear all of the numbers recognized by the system, say “Verify” at any time and the system will repeat them.

4. After the complete number has been entered, say “Store”. The system responds with “Please say the name tag” followed by a tone.

5. Say a name tag for the phone number. The name tag is recorded and the system responds with “About to store <name tag>. Does that sound OK?”.

• If the name tag does not sound correct, say “No” and repeat Step 5.

• If the name tag sounds correct, say “Yes” and the name tag is stored. After the number is stored the system returns to the main menu.

    See also:

    Setting the Time and Date (With Date Display)
    1. Press the CONFIG button and select Time and Date Settings, or press . 2. Select Set Time or Set Date. 3. Turn the Menu knob to adjust the highlighted value. 4. Press SELECT to select the n ...

    Fog Lamps
    To turn on the fog lamps, the ignition and the headlamps or parking lamps must be on. If the fog lamps are turned on while the exterior lamp switch is in the AUTO position, the headlamps come on ...

    Exterior
    For 2006, a new front grille and tri-shield emblem are installed. Sculpted wheel flares and shoulders are meant to enhance the Rainier's appearance. Clear headlights have offset high/low beam fixt ...