Using the Store Command
The store command allows a phone number to be stored without entering the digits individually.
1. Press and hold for two seconds.
The system
responds with “Ready” followed by a tone.
2. Say “Store”. The system responds with “Store, number please” followed by a tone.
3. Say the complete phone number to be stored at once with no pauses.
• If the system recognizes the number it responds with “OK, Storing” and repeats the phone number.
• If the system is unsure it recognizes the phone number, it responds with “Store” and repeats the number followed by “Please say yes or no”. If the number is correct, say “Yes”. If the number is not correct, say “No”. The system will ask for the number to be re-entered.
4. After the system stores the phone number, it responds with “Please say the name tag” followed by a tone.
5. Say a name tag for the phone number. The name tag is recorded and the system responds with “About to store <name tag>. Does that sound OK?”.
• If the name tag does not sound correct, say “No” and repeat Step 5.
• If the name tag sounds correct, say “Yes” and the name tag is stored. After the number is stored the system returns to the main menu.
See also:
Remote Keyless Entry (RKE) System
The Remote Keyless Entry (RKE)
transmitter will work up to 20 m
(65 ft) away from the vehicle. On
vehicles with remote start the
distance will be greater.
Press the button to extend the key ...
Leaving the Vehicle with the Engine Running
WARNING!
It can be dangerous to leave the
vehicle with the engine running.
The vehicle could move suddenly
if the shift lever is not fully in
P (Park) with the parking brake
firmly set. And, ...
Power Steerin
If power steering assist is lost because the engine stops or the power steering system is not functioning, the vehicle can be steered but it will take more effort. ...