Deleting a Paired Phone

1. Press and hold seconds. The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3. Say “Delete”. The system asks which phone to delete followed by a tone.

4. Say the name of the phone to be deleted. If the phone name is unknown, use the “List” command for a list of all paired phones. The system responds with “Would you like to delete <phone name>? Yes or No” followed by a tone.

5. Say “Yes” to delete the phone. The system responds with “OK, deleting <phone name>”.

    See also:

    Jump Starting
    For more information about the vehicle battery, see Battery  If the battery has run down, try to use another vehicle and some jumper cables to start your vehicle. Be sure to use the following st ...

    Starting the Vehicle with a Low Transmitter Battery
    If the transmitter battery is weak, the DIC may display NO REMOTE DETECTED when you try to start the vehicle. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time. To star ...

    USB Port
    Not all USB drives are compatible with the USB port. Check the height of the USB drive prior to closing the arm rest. For vehicles with a USB port, the following devices may be connected and contro ...