Using the Dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Dial.” The system responds “Dial using <phone name>.

Number please,” followed by a tone.

3. Say the entire number without pausing.

► If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

► If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes.” The system responds “OK, Dialing” and dials the number. If the number is not correct, say “No.” The system will ask for the number again.

    See also:

    Glove Box
    The glove box is located on the passenger side of the instrument panel. Lift up on the lever to open it. ...

    Using the Auxiliary Input Jack
    The radio system has an auxiliary input jack located on the lower right side of the faceplate. This is not an audio output; do not plug the headphone set into the front auxiliary input jack. How ...

    Using this Manual
    To quickly locate information about the vehicle, use the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. ...