Compass Calibration Procedure

1. Before calibrating the compass, check that the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window, sunroof, climate controls, seats, etc. during the calibration procedure.

2. Press the vehicle information button until PRESS TO CALIBRATE COMPASS displays. TO CALIBRATE COMPASS displays.

3. Press the set/reset button to start the compass calibration.

4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 5 mph (8 km/h) to complete the calibration.

The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete.

The DIC display will then return to PRESS CALIBRATE COMPASS. TO CALIBRATE COMPASS.

    See also:

    Engine Heater
    The engine heater, if available, can help in cold weather conditions at or below −18°C (0°F) for easier starting and better fuel economy during engine warm-up. Plug in the heater at least ...

    Inserting a CD or DVD
    With the printed side facing up, insert a disc into the slot until it is drawn in. ...

    Parking Brake
    The vehicle has an Electric Parking Brake (EPB). The switch for the EPB is in the center console. The EPB can always be activated, even if the ignition is off. To avoid draining the battery, do ...