Taillamps and Turn Signal Lamps
To replace a taillamp or turn signal bulb, do the following:
1. Open the liftgate.
2. Remove the two
screws from the
taillamp assembly.
3. Pull the taillamp assembly away from the
vehicle.
4. Unclip the wiring harness (A) and remove the
three socket retaining screws (B).
5. Remove the socket plate.
6. Holding the socket, pull the old bulb to
release it from the socket.
7. Push the new bulb into the socket until it clicks.
8. Reinstall the socket plate and tighten the
three screws.
9. Reconnect the wiring harness.
10. Reinstall the taillamp assembly by lining up
the locator pins with the retainers in the
vehicle’s body.
11. Reinstall the two screws and tighten
See also:
Spare Tire
Your vehicle, when new, had a fully-inflated
spare tire. A spare tire may lose air over time, so
check its inflation pressure regularly.
After installing the spare tire on your vehicle, you
should ...
Service Parts Identification Label
This label, located either in the glove box or the trunk area, has the following information:
► Vehicle Identification Number (VIN).
► Model designation.
► Paint information.
...
Winter Tires
Consider installing winter tires on the vehicle if frequent driving on snow or ice covered roads is expected. All season tires provide good overall performance on most surfaces, but they may not offer ...