Programming the Power Windows
If the battery on the vehicle has been recharged, disconnected, or is not working, the windows with the express-up feature will need to be reprogrammed for the feature to work. Before reprogramming, replace or recharge the vehicle's battery.
To program each front window:
1. The ignition is in ACC/ ACCESSORY or ON/RUN, or in RAP.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed. Repeat the process for the other windows.
See also:
Loading and Ejecting Discs
To load a disc:
1. Turn the ignition on.
2. Insert a disc into the slot. The
player pulls it in the rest of the
way. If the disc is damaged or
improperly loaded, there is an
error and the di ...
Lumbar Adjustment
To adjust the lumbar support:
► Press and hold the front or rear of the control to increase or decrease lumbar support.
► Press and hold the top or bottom of the control to raise or lo ...
Exterior Lamp Controls
The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel.
Turn the control to the following positions:
(Off): Turns off the exterior lamps. The ...