Starting the Vehicle

To start the engine using the remote start feature:

1. Aim the RKE transmitter at the vehicle.
2. Press and release 3. Immediately after completing Step 2, press and hold.
3. Immediately after completing Step 2, press and hold or for about two seconds if the vehicle is not in view. until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Start the vehicle before driving.

    See also:

    Battery
    This vehicle has a standard 12-volt battery. Refer to the replacement number on the original battery label when a new standard 12-volt battery is needed. eAssist vehicles also have a high v ...

    Programming without a Recognized Transmitter (Keyless Access Vehicles Only)
    If there are no currently recognized transmitters available, follow this procedure to program up to five transmitters. This feature is not available in Canada. This procedure will take appro ...

    Manual Seats
    Manual Seats A. Seatback Recline Lever B. Height Adjustment Switch C. Seat Position Handle To adjust the seat position: 1. Pull the handle (C) under the front of the seat cushion. 2. Slide t ...