Starting the Vehicle

1. Aim the RKE transmitter at the vehicle. 2. Press and release 2, press and hold until the turn signal. 3. Immediately after completing Step 2, press and hold lamps flash, or for about two seconds if the vehicle is not in view. until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Checking Engine Oil
    It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the oil must be warm and the vehicle must be on level ground. The engine oil dipstick handle is ...

    Glove Box
    Lift up the handle to open the glove box. It contains a pen holder and a coin holder. ...

    Ride Control System Messages
    SERVICE TRACTION CONTROL This message displays when there is a problem with the Traction Control System (TCS). When this message is displayed, the system will not limit wheel spin. Adjust your dr ...