SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, or 3.5m(11 ft). This zone starts at each side mirror and goes back approximately 5.0 m(16 ft). The height of the zone is approximately between 0.5 m(1.5 ft) and 2.0m(6 ft) off the ground.
The SBZA detection zones do not change if the vehicle is towing a trailer. So be extra careful when changing lanes while towing a trailer.
See also:
Turn Signals When Towing a Trailer
The arrows on the instrument panel flash whenever signaling a
turn or lane change. Properly hooked up, the trailer lamps also flash, telling other
drivers the vehicle is turning, changing lanes, o ...
Programming Transmitters to the Vehicle
Only RKE transmitters programmed to the vehicle will work. If a transmitter is
lost or stolen, a replacement can be purchased and programmed through your dealer.
The vehicle can be reprogrammed so ...
CD Messages
CHECK CD: If this message appears on the
display and/or the CD ejects, it could be for one of
the following reasons:
• It is very hot. When the temperature returns to
normal, the CD should pla ...