Using the Directory Command

The directory command lists all of the name tags stored by the system. To use the directory command:

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Directory”. The system responds with “Directory” and then plays back all of the stored name tags. When the list is complete, the system returns to the main menu.

    See also:

    Radio Messages for XM™ Only
    See XM Radio Messages later in this section for further detail. ...

    Overheated Engine Protection Operating Mode
    If an overheated engine condition exists and the message ENGINE OVERHEATED STOP ENGINE is displayed, an overheat protection mode which alternates firing groups of cylinders helps prevent engine ...

    Turning the System On or Off
    /VOL (Power/Volume): Press to turn the system on and off. Automatic Switch-Off If the infotainment system has been turned on after the ignition is turned off, the system will turn off automatic ...