Deleting a Paired Phone

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Bluetooth.” The system responds “Bluetooth ready,” followed by a tone.

3. Say “Delete.” The system asks which phone to delete followed by a tone.

4. Say the name of the phone to be deleted. If the phone name is unknown, use the “List” command for a list of all paired phones. The system responds “Would you like to delete <phone name>? Yes or No,” followed by a tone.

5. Say “Yes” to delete the phone.

The system responds “OK, deleting <phone name>.”

    See also:

    Key and Lock Messages
    NO REMOTE DETECTED This message displays when the transmitter battery is weak on vehicles with keyless access. See “Starting the Vehicle with a Low Transmitter Battery” under Remote Key ...

    Using the Digit Store Command
    The digit store command allows a phone number to be stored by entering the digits individually. 1. Press and hold for two seconds. The system responds with “Ready” followed by a tone. 2. ...

    Trunk
    WARNING! Exhaust gases can enter the vehicle if it is driven with the liftgate, trunk/hatch open, or with any objects that pass through the seal between the body and the trunk/hatch or lift ...