Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press
.
3. Immediately after completing Step 2, press and
hold 
until the turn signal lamps
flash.
When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.
The doors will be locked and the climate control system may come on.
The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.
See also:
Exterior Lamp Controls
Exterior Lamp Controls
The exterior lamp control is located
on the instrument panel on the
outboard side of the steering wheel.
Turn the control to the following
positions:
(Off): Turns of ...
Removing and Replacing the Floor Mats
Pull up on the rear of the floor mat to unlock each retainer and remove.
Reinstall by lining up the floor mat retainer openings over the carpet retainers
and snap into position.
Make sure the fl ...
Heated Seats
On vehicles with heated seats, the controls are located
on the front doors and the ignition must be on to
use the feature.
: Press to heat the seat and
seatback.
: Press to heat the seatback ...