How to Change the Video Format when inthe Auxiliary Mode

The auxiliary input video format is preset to NTSC.

In some countries, the video format may be in the PAL system. To change the video format, perform the following:

1. Press the display menu button.
2. Press the down arrow button to highlight the Video Format option.
3. Press the enter button to select Video Format.
4. Press the right or left arrow button to select the desired video format.
5. Press the enter button to accept the change.

    See also:

    GM Mobility Reimbursement Program
    This program, available to qualified applicants, can reimburse you up to $1,000 of the cost of eligible aftermarket adaptive equipment required for your vehicle, such as hand controls or a whe ...

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, 3.5 m (11 ft). This zone starts at each side mirror and goes back approximately 5 m (16 ft). The hei ...

    Infotainment Control Buttons
    The buttons on the faceplate are used to start primary functions while using the infotainment system. VOL/ (Volume/Power): 1. Press to turn the system on and off. 2. Turn to adjust the volum ...