Erasing Universal Home RemoteButtons

To erase programming from the three Universal Home Remote buttons do the following:

1. Press and hold down the two outside buttons until the indicator light begins to flash, after 20 seconds. Do not hold the two outside buttons for longer than 30 seconds.
2. Release both buttons.

The Universal Home Remote is now in the training (learning) mode and can be programmed at any time beginning with Step 2 under “Programming Universal Home Remote” shown earlier in this section.

Individual buttons cannot be erased, but they can be reprogrammed. See “Reprogramming a Single Universal Home Remote Button” following this section.

    See also:

    Cupholders
    There are two cupholders in the center console with a removable liner. To remove the liner, lift up on the notch on the underside of the rear of the cupholder. Rear Seat There are two cupholders ...

    Replacement Bulbs
    For replacement bulbs not listed here, contact your dealer/retailer. ...

    Using the Tire Sealant and Compressor Kit to Temporarily Seal and Inflate a Punctured Tire
    Follow the directions closely for correct sealant usage. When using the tire sealant and compressor kit during cold temperatures, warm the kit in a heated environment for five minutes. Thi ...